|
|
Dually Iso Pegs with 1-1/4in diameter clamps pr
by Kuryakyn USA
SKU
KU-7993
U.S. Pat # Des 411,440
These highway pegs utilize our unique offset mount to allow riders a range of adjustment not possible with other clamp-on style highway pegs. The offset can be rotated 360 degrees in a 4-inch diameter circle to accommodate tall, short, or average height riders.
These can be installed on any round tubing (frames or engine guards), but it is important to keep in mind that the footpeg itself will end up perpendicular to the bar to which it is mounted. If your engine guard is angled in such a way so that the peg will not be level once installed, look at our Right Angle Mounts and male adapters with adjustable stop.
Helpful Hint: If you are unsure of the diameter of the tubing on which you'd like to install the highway pegs and don't have a dial at your disposal, here is an easy way to figure it out. You'll need a piece of heavy paper or cardboard, a ruler, a pencil, and a scissors. Use the pencil and ruler to make to marks on the edge of the paper 1" apart. Take the scissors and cut lines perpendicular to the edge of the paper at the marks you just made. Fold the resulting flap of paper out of the way. Next, take the piece of paper to the bike and check to see if the tubing will slip into the opening you've made in the edge of the paper. If the opening is too small, repeat the procedure enlarging the opening to 1-1/8", 1-1/4", 1.35", and 1-1/2" until you find one that will fit.
|